VVDI2 BMW V4.3.0 FEM BDC key program & KM reset tested 100% works

VVDI2 latest software version V4.3.0 update: BMW V4.3.0 adds BMW FEM/BDC key learn, erase key, FEM/BDC KM reset etc. Below parts incl. VVDI2 BMW FEM /BDC authorization, update content, free download link and using tips.

VVDI2 BMW V4.3.0 Update:

*** Require firmware V4.3.0

VVDI2 BMW V4.3.0 Capabilities:

1.support make new key with ignition switch(support adding spare key and all key lost, all key lost require ISN)

2.support reset FEM/BDC KM(cluster require reset manually)

3.support erase key(after erasing the key position become blank position)

4.support backup coding

5.support restore coding

VVDI2 V4.3.0 download free:
https://mega.nz/#!W1pSRRTL!0n8OX4wshaB1s0O06SDhTR0KvO32nPHZWg4CQjBMdrA

The user who have VVDI2 interface with BMW software could update SW and FW self directly, only connect your VVDI unit internet and press update FW and SW…

VVDI2 BMW V4.3.0 make FEM BDC keys in 3 steps: get key info->programming FEM/BDC system->make keys

Tips:
1.backup coding and restore coding can direct operation generally.
2.add keys, reset KM, erase key must programming FEM/BDC system first
3.in FEM/BDC interface, if ‘get key info’ the type not support, it will show: customer should use “BMW E-sys software” program FEM/BDC system. then programming FEM/BDC system with VVDI2-BMW
4.when operation on ‘programming FEM/BDC system ‘interface, please don’t close this software window until all procedures completed.
5.programming FEM/BDC system, require soldering and get eeprom.（FEM 95128 chip, BDC 95256 chip）usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6.programming FEM/BDC system, must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car, but with problem (such as the remote control cannot start the car
or the car with window problem)please use “BMW E-sys software” coding for FEM/BDC system.